AMP 50 Automatically

Introduction

AMP 50 belongs to automatic mounting press with the function of the water cooling system.
It applies to all the hot mounting material plastic.
After setting mounting parameters of the heating temperature, dwell time and loading pressure, filling in the sample and the mounting material, and fastening the cover, just press the start button, it will finish the mounting work without the operator watching near the machine.
The operator can change 4 kinds of mounting moulds in accordance with different sample size freely..
It is allowed that the operator can mount 2 specimens at same time with different moulds

Features

After setting mounting parameters of the heating temperature, dwell time and loading pressure, filling in the sample and the mounting material, and fastening the cover, just press the start button, it will finish the mounting work without the operator watching near the machine.
The operator can change 4 kinds of mounting moulds in accordance with different sample size freely..
It is allowed that the operator can mount 2 specimens at same time with different moulds
Specification

Model	AMP 50
Moulding specification	Ø25mm, Ø30mm, Ø40mm, Ø50mm
Power	1P~220V, 50Hz
Max power consumption	1800W
System pressure setting range	0~2MPa
Temperature setting range	0~180℃
Setting range of holding time	0~99min99sec
Dimension	615×510×500mm
Cooling system	Water-cooling
Weight	110 kg

Up Page：None
Next Page：MMP22 Manually